Raihan P•••

About

On the record

I am a graduate of Oil and Gas Processing Engineering at PEM Akamigas. my GPA is 3.72 out of 4.00. I work at SKies Engineering Consultant (Engineering Consultant under LAPI ITB) as a Staff Process Engineer. I was responsible for various tasks related to the design, analysis, and optimization of engineering processes. My work is related to HTRI, ALOHA, NAVISWORKS, IBM SPSS, Aspen HYSYS, Aspen HYSYS, Aspen Plus, Aspen Exchanger Design and Rating (EDR), Vessel software, AutoCAD (To create p & id), CAESAR II, Fisher (Control Valve), and document creation for clients such as Pertamina KPI. Details of Last internship as a junior engineer 1)JOB Pertamina-Medco E&P Tomori Sulawesi (Field experience)-Conducting an in-depth study of the Process Flow Diagram (PFD) of the AGRU unit as part of the final project and internship. Understand Piping and Instrumentation Diagram also legend-Navisworks application with guidance from mentors-Performed detailed calculations related to length equivalent and hydraulic pump for the vessel degassing column addition project-Collected relevant data for Management of Change (MOC) purposes from various sources and analyzed the data-Involved in the design of process equipment such as STHE heat exchanger, vessel, and column-Attended HYSYS dynamic training from ASPEN with guidance from JOB engineer mentor-Performed the process of taking produced water samples from the SNOT7002 tank with predetermined steps-Understand and master the use of ALOHA software for safety purposes in the work environment-Carefully study the data sheet of gas refinery process equipment to support the final project in redesigning the AGRU unit-Joined in the repair work at the AGCU Unit together with the supervisor-Carried out tank volume measurement tasks at SNOT6001A with established procedures-Observed and learned the JOB MEDCO flare monitoring process using drones as a tool-Attended the weekly JOB TOMORI Alarm management meeting to evaluate the alarms in the control room-Organized inspection of negative type pump in H2SO4 unit by troubleshooting with supervisor-Developed an understanding of control room functions and operations, including Emergency Shutdown System (ESD) and cascade control-Performed HYSYS simulation to estimate the temperature at the end of the pipe by considering several parameters-Followed the mentor to Panca Amara Utama (PAU) to take measurements at the instrument air compressor-Checked the pressure on the fuel gas supply and nitrogen blanket gas on board SNOV6005B by following the established procedures.